- Home /
- Concept-surface /
- Surface /
- FLAT MATT SCUFFING PASTE 1L
Shop Now
- Paint Selector
- Abrasives
- 3m
- Adhesives, Sealants & Tapes
- Air Tools
- Anest Iwata
- Baslac
- Brunox
- Brushware
- Carsystem
- Charts & Literature
- Concept-surface
- Dent Pullers
- Drills & Accessories
- Electrical
- Fasteners
- Files & Hacksaws
- Fillers & Spreaders
- Green Rhino
- Gys
- Ies Epoxies & Sealers
- Indasa
- Infrared Lights
- Knives/ Blades & Scrapers
- Lights
- Malco / Presta
- Masking Products
- Mbx Metal Blaster
- Measuring Tools
- Mipa
- Misc Fluids & Lubricants
- Misc Tools
- Pacer
- Pacer & Norbin Primers & Clears
- Paint Cups/ Strainers/ Tack
- Panelbeating Dollies & Hammers
- Plastic Repair
- Por 15
- Protective Gear
- Rubbers & Trims
- Stands
- Transtar
- Welding
Surface
FLAT MATT SCUFFING PASTE 1L
One-step, water based abrasive cleaning and preparation system for use on all paint finishes. Ideal for difficult to prep areas such as bumpers, door sills and for the blending-in of new paint. Fast, efficient, easy to clean-up• 3-in-1 Saves Time: Triple-action Flatting Paste, abrades, cleans and completely degreases in one easy step.
• Consistent even key: enhances coating adhesion by creating smooth even surface preventing any ‘swelling’ in blend areas. Prevents problems of scratches or tramlines that can sometimes appear through the clear coat.
• Easy to apply: Works fast in ideal combination with nylon finishing pads (grey/ultra-fine or copper/superfine) maintaining consistent abrasive action. Can be used with pure cotton cloth for areas around trim or under seals.
• Corners and crevices: Uniform matting and cleaning action gives the perfect key in hard-toreach areas – e.g: doorjambs and sills, drip channels, door locks, handles etc.
• Water-based: Easy to wipe off from prepared surfaces, leaving no residues to impair paint adhesion.
• No problems: Non-staining on rubber mouldings or trims. Silicone free.
• Universal: For use on all today's advanced refinish paint finishes including: Water based, High Solids (HS), Medium Solids (MS) and OEM finishes.
• Plastic-Prep:Ideal for cleaning and abrading plastic bumpers and rubber parts prior to painting.
HOW TO USE:
Shake well before use. Wash away from surface area any large dirt particles that can cause scratches. Using clean water, dampen the nylon' hand pad; wring-out any excess water. Apply Flat-Matt to hand pad or direct to panel (allowing approximately 10gms. per average sized panel). Using medium to firm pressure abrade surface
using even pad strokes in a criss-cross action, until the panel is thoroughly cleaned and the desired matt finish is obtained. All pre-treated areas must be wiped down thoroughly with a damp cloth or solvent wipe and dried prior to paint application.